Subject: Mike Collier turbo Long EZ
From: Rotary Engine
Date: 6/26/2007, 2:42 PM
To: AARotary Engine




Paul
  How far do you have the engine from the firewall?  I think Perry's in
only a couple of inches... I'm trying to snug mine up as close as
possible.  Here are a couple of pictures with the engine positioned...
Still have to figure out what to do with the Turbo and intake... Sticks
up just a little... Also, need to finish the firewall before I weld the
MM braces. I want to ensure there is no interference between the
controls and the MM.

Mike C.

I am going to move it closer.

Are you going to use a jack screw linear actuator as a front strut
mount. Great idea.
I think Burt Rutan would be really interested in this. Imagine a
vectored thrust Long EZ. Should help with takeoff and maybe landing.
Should turn like an F35 :)

--
Paul Lamar ...No rotor no motor.


Are those turbo fittings aluminum?  Should be steel if I'm not mistaken.

Mark St.


Hi Mark
 Good catch.  I'll take a closer look when I start integrating the Oil
cooler and Intercooler.  I believe the Oil in line has an aluminum
fitting but the out line to the sending unit is steel.  The water lines
are aluminum.  I haven't  thought much about he lines yet because I know
I'm going to have to replace some of them as I integrate the radiator,
and coolers.

Mike C.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.