After searching through many salvage yards looking for a radiator that
would fit under the engine in the RV-9A, I finally found one. It is in
my 2005 Dodge Hemi PU! By turning it 90 degrees and moving the exhaust
pipe a little it fits just fine, at least in the 3D. JPGs are attached
showing the arrangement. The muffler shown will not be used. Instead I
plan on a QUIET muffler under the fuse.
The rad core dimensions are 24" X 14" X 1.75" and the red boxes at the
end are the tanks, each 1.5 W X 3" H. We plan to weld custom tanks on
with the hose barbs on the firewall end. This produces a core volume of
588 cu. in.
A couple of questions.
1. What do I do about the different lengths of the rad and the oil
cooler to avoid a discontinuity, if anything?
2. How and where do I join the two exhaust pipes for max. efficiency?
I heard that the Swiss builders invented their own muffler. Is this a
good muffler and if so, are the plans available?
I really hope I can avoid paying over $400 for a racing rad.
Doc Custer
Retired Software Engineer and sometime Audiologist
Nice 3D's Doc.
No solution for the first question :) All aluminum racing rads are $200 in
the Summit catalog. I bought a Howe. If yours has plastic tanks beware.
Have somebody weld up aluminum tanks. Bad place to save money.
Join the pipes at 32 inches. Careful on the muffler.
Most don't hold up. Tracy found one that seems to hold up.
Last picture. I think it is a Flow Master from Warshawsky or some such.
Anyway top and bottom are pressed steel and welded together around
the sides.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.