After searching through many salvage yards looking for a radiator that
would fit under the engine in the RV-9A, I finally found one. It is in
my 2005 Dodge Hemi PU! By turning it 90 degrees and moving the exhaust
pipe a little it fits just fine, at least in the 3D. JPGs are attached
showing the arrangement. The muffler shown will not be used. Instead I
plan on a QUIET muffler under the fuse.
The rad core dimensions are 24" X 14" X 1.75" and the red boxes at the
end are the tanks, each 1.5 W X 3" H. We plan to weld custom tanks on
with the hose barbs on the firewall end. This produces a core volume of
588 cu. in.
A couple of questions.
1. What do I do about the different lengths of the rad and the oil
cooler to avoid a discontinuity, if anything?
2. How and where do I join the two exhaust pipes for max. efficiency?
I heard that the Swiss builders invented their own muffler. Is this a
good muffler and if so, are the plans available?
I really hope I can avoid paying over $400 for a racing rad.
Doc Custer
Retired Software Engineer and sometime Audiologist
Nice 3D's Doc.
No solution for the first question :) All aluminum racing rads are $200 in
the Summit catalog. I bought a Howe. If yours has plastic tanks beware.
Have somebody weld up aluminum tanks. Bad place to save money.
Join the pipes at 32 inches. Careful on the muffler.
Most don't hold up. Tracy found one that seems to hold up.
Last picture. I think it is a Flow Master from Warshawsky or some such.
Anyway top and bottom are pressed steel and welded together around
the sides.
--
Paul Lamar ...No rotor no motor.
If needed we will weld on AL tanks.
Has anybody tested the plastic tanks to, say, 100 psi? If not, we will. If
doing this yourself, be careful: fill the rad with water as full as you can
get it and then carefully add air pressure. Air can result in explosive
decompression if the rad fails. Water only squirts.
In any event we need to move the inlet and outlets and fill/rad cap
location, so will probably have to weld on AL tanks to get the desired
locations. I would like to know how strong a salvaged rad is, regardless.
Especially the core as the tanks can easily be replaced.
One more word of caution: each rad probably has a different strength. Test
before installing.
I think I will do a 3D of the diffuser, rad and oil cooler. That will ease
the making of a male mold.
Doc Custer
Retired Software Engineer and sometime Audiologist
My experience is plastic tanks gets old, brittle and crack. Recent information
suggest there is something in the antifreeze that makes them brittle.
As far as I know we have never had a rad split due to pressure so far. Of course
the pressure is limited to 30 psi. I cannot say that about oil
coolers however as rotary engine oil coolers are subjected to up to 150 psi.
Consider a two pass rad to get the inlet and the outlet on the
same end. Eases the plumbing.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.