The first production run of slide throttles is complete. I will be
shipping them out starting next week. As soon as I do, I will post some
pix of them.
The machinist has the drawings for the 20B slide throttles. I expect he
will be making a prototype sometime in the next week or two. Any
interest?
Doc Custer
Retired Software Engineer and sometime Audiologist
Here is what it looked like at Sun n Fun.
Paul Lamar ...No rotor no motor.
Those are the prototypes. The production models are lighter by removing
the
rectangular end and making it rounded. Also slightly shorter. And the
cover
plates are now 0.125 instead of 0.250, a good saving.
Anodizing is optional.
Doc Custer
Retired Software Engineer and sometime Audiologist
If you don't mind Doc I am going to make a new Teflon
slide and use your housings to test the mech fuel injection
on the p-port RX8 dyno engine. Other than a couple of 1/16th holes
in the spacer nothing else will be modified.
Paul Lamar
Nice work Doc!
George ( down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.