Subject: Oil cooler air flow
From: Rotary Engine
Date: 6/28/2007, 10:52 AM
To: AARotary Engine


Paul;
Now that we are back to summer OAT; I'm finding that my power level is
limited by oil temp. The wing root installation just isn't working as well
as I had hoped. .  It is clear from my temp data that the air flow is
inadequate.  I cut back part of the exit fairing (something along the lines
that you had suggested months ago) which I though could be a solution, but
it made no improvement.  The next step is to get some pressure measurements,
and maybe some tuft testing to see what's going on.

I was looking in my files for a photo of your manometer setup, but didn't
find it.  Maybe you could post it again.  One issue is that I have no ready
access for running tubes, especially on the inlet side; so I'll have to
figure out something.  One thought is electronic pressure sensors; I could
find spaces to run wires.  Anyone have a lead on inexpensive sensors?

Al

You need my How to Cool Your Wankel book Al :)
Free Scale pressure sensors run about $10 each and are the sophisticated
way to go. They have some new real tiny surface mount versions. 1.5 psi max.
You need a data acq system however.

The quick and dirty way is a manometer and drip irrigation tubing.

I would ponder the ME109 way of mounting rads in wings.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.