Subject: Oil cooler air flow
From: Rotary Engine
Date: 6/28/2007, 11:59 AM
To: AARotary Engine


    Paul;
    Now that we are back to summer OAT; I'm finding that my power level is
    limited by oil temp. The wing root installation just isn't working
    as well
    as I had hoped. .  It is clear from my temp data that the air flow is
    inadequate.  I cut back part of the exit fairing (something along
    the lines
    that you had suggested months ago) which I though could be a
    solution, but
    it made no improvement.  The next step is to get some pressure
    measurements,
    and maybe some tuft testing to see what's going on.

    I was looking in my files for a photo of your manometer setup, but
    didn't
    find it.  Maybe you could post it again.  One issue is that I have
    no ready
    access for running tubes, especially on the inlet side; so I'll have to
    figure out something.  One thought is electronic pressure sensors; I
    could
    find spaces to run wires.  Anyone have a lead on inexpensive sensors?

    Al

    You need my How to Cool Your Wankel book Al :)
    Free Scale pressure sensors run about $10 each and are the sophisticated
    way to go. They have some new real tiny surface mount versions. 1.5
    psi max.
    You need a data acq system however.

    The quick and dirty way is a manometer and drip irrigation tubing.

    I would ponder the ME109 way of mounting rads in wings.
    --
    Paul Lamar ...No rotor no motor.

What's Al's installation look like?


Matt-

OK here they are.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.