Subject: Oil cooler air flow
From: Rotary Engine
Date: 6/28/2007, 2:15 PM
To: AARotary Engine



        Paul;
        Now that we are back to summer OAT; I'm finding that my power
   level is
        limited by oil temp. The wing root installation just isn't working
        as well
        as I had hoped. .  It is clear from my temp data that the air
   flow is
        inadequate.  I cut back part of the exit fairing (something along
        the lines
        that you had suggested months ago) which I though could be a
        solution, but
        it made no improvement.  The next step is to get some pressure
        measurements,
        and maybe some tuft testing to see what's going on.

        I was looking in my files for a photo of your manometer setup, but
        didn't
        find it.  Maybe you could post it again.  One issue is that I have
        no ready
        access for running tubes, especially on the inlet side; so I'll
   have to
        figure out something.  One thought is electronic pressure
   sensors; I
        could
        find spaces to run wires.  Anyone have a lead on inexpensive
   sensors?

        Al

        You need my How to Cool Your Wankel book Al :)
        Free Scale pressure sensors run about $10 each and are the
   sophisticated
        way to go. They have some new real tiny surface mount versions. 1.5
        psi max.
        You need a data acq system however.

        The quick and dirty way is a manometer and drip irrigation tubing.

        I would ponder the ME109 way of mounting rads in wings.
        --
        Paul Lamar ...No rotor no motor.

   What's Al's installation look like?


   Matt-

   OK here they are.
   --
   Paul Lamar ...No rotor no motor.


Thanks..

I'll bet the exit is in a region of reasonably thick boundary layer.  If
so, the flow on the surface may be very slow or even reversed in places
- leading to relatively high exit pressures and low flow through the
cooler.  I think making the exit lip taller should help things, though
not pretty.  Like a Gurney Flap, or the cowl exhaust on an older Cessna..


Matt-

What do you think of the ME109 idea?


Paul Lamar


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.