Subject: Oil cooler air flow
From: Rotary Engine
Date: 6/28/2007, 2:16 PM
To: AARotary Engine



            Paul;
            Now that we are back to summer OAT; I'm finding that my
       power level is
            limited by oil temp. The wing root installation just isn't
       working
            as well
            as I had hoped. .  It is clear from my temp data that the
       air flow is
            inadequate.  I cut back part of the exit fairing (something
       along
            the lines
            that you had suggested months ago) which I though could be a
            solution, but
            it made no improvement.  The next step is to get some pressure
            measurements,
            and maybe some tuft testing to see what's going on.

            I was looking in my files for a photo of your manometer
       setup, but
            didn't
            find it.  Maybe you could post it again.  One issue is that
       I have
            no ready
            access for running tubes, especially on the inlet side; so
       I'll have to
            figure out something.  One thought is electronic pressure
       sensors; I
            could
            find spaces to run wires.  Anyone have a lead on
       inexpensive sensors?

            Al

            You need my How to Cool Your Wankel book Al :)
            Free Scale pressure sensors run about $10 each and are the
       sophisticated
            way to go. They have some new real tiny surface mount
       versions. 1.5
            psi max.
            You need a data acq system however.

            The quick and dirty way is a manometer and drip irrigation
       tubing.

            I would ponder the ME109 way of mounting rads in wings.
            --
            Paul Lamar ...No rotor no motor.

       What's Al's installation look like?


       Matt-

       OK here they are.
       --
       Paul Lamar ...No rotor no motor.


Thanks..

I'll bet the exit is in a region of reasonably thick boundary layer.  If
so, the flow on the surface may be very slow or even reversed in places
- leading to relatively high exit pressures and low flow through the
cooler.  I think making the exit lip taller should help things, though
not pretty.  Like a Gurney Flap, or the cowl exhaust on an older
Cessna..  To try the theory, I'd just rivet a piece of l-stock onto the
top of the exit.  Maybe something 1/2" high.  Maybe VG's ahead of the
exit could help too (like the ones in front of the inlet - which I
suspect may be less necessary)..

Tufting or liquid soap testing seem like good ideas as well as pressure
measurements...

http://www.thinkingdevices.com/TEfences/AC01/


Matt-



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.