Subject: Oil cooler air flow
From: Rotary Engine
Date: 6/28/2007, 5:33 PM
To: AARotary Engine


             Paul;
             Now that we are back to summer OAT; I'm finding that my power
        level is
             limited by oil temp. The wing root installation just isn't
   working
             as well
             as I had hoped. .  It is clear from my temp data that the air
        flow is
             inadequate.  I cut back part of the exit fairing
   (something along
             the lines
             that you had suggested months ago) which I though could be a
             solution, but
             it made no improvement.  The next step is to get some pressure
             measurements,
             and maybe some tuft testing to see what's going on.

             I was looking in my files for a photo of your manometer
   setup, but
             didn't
             find it.  Maybe you could post it again.  One issue is
   that I have
             no ready
             access for running tubes, especially on the inlet side; so
   I'll
        have to
             figure out something.  One thought is electronic pressure
        sensors; I
             could
             find spaces to run wires.  Anyone have a lead on inexpensive
        sensors?

             Al

             You need my How to Cool Your Wankel book Al :)
             Free Scale pressure sensors run about $10 each and are the
        sophisticated
             way to go. They have some new real tiny surface mount
   versions. 1.5
             psi max.
             You need a data acq system however.

             The quick and dirty way is a manometer and drip irrigation
   tubing.

             I would ponder the ME109 way of mounting rads in wings.
             --
             Paul Lamar ...No rotor no motor.

        What's Al's installation look like?


        Matt-

        OK here they are.
        --
        Paul Lamar ...No rotor no motor.


   Thanks..

   I'll bet the exit is in a region of reasonably thick boundary layer.  If
   so, the flow on the surface may be very slow or even reversed in places
   - leading to relatively high exit pressures and low flow through the
   cooler.  I think making the exit lip taller should help things, though
   not pretty.  Like a Gurney Flap, or the cowl exhaust on an older
   Cessna..


   Matt-

   What do you think of the ME109 idea?


   Paul Lamar



Sounds great..  I'm just trying to think of a way to test a theory
without expending a bunch of effort.  Seems like it might be adequate to
provide a hinge line at the front edge of the existing exit structure
(directly above the heat exchanger).  As a first stab, don't even put an
actuator on it - just a fixed strut to hold the flap sticking out further.


Regards,

Matt-



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.