Subject: PSRU oil leak
From: Rotary Engine
Date: 6/28/2007, 1:01 PM
To: AARotary Engine





        -- Rotary Engine

        SNIP
        The seal was a National part.  Going from memory, I think the
    p/n was
        3500090, or something similar.  I would have to check on that to be
        sure.  It was a nice tight fit.

        Mark St.
        Hi Mark,

        Can you check the seal P/N?  I'm working around a National P/N
    350909
        and before I get too carried away I'd like to make sure I've got the
        correct seal. I'm embedding the seal in a new housing "half" to
    control
        the eccentricities better. This will also provide back-up to the
    seal so
        internal pressure forces tighter sealing rather than the tendency to
        blow the seal out. ( IOW's I'm using housing material to act
    like your
        screwed in retainer ).      Thanx    Dave M

        I would not muck about with cheap shaft seals. I would use these.

        Paul Lamar



    Paul,
    Now you tell me!!!  There is no way that I'm pulling that PSRU again
    unless I have to for some other reason.  The seal I used is exactly the
    same as what Tracy installed new.  In fact, I took the old plate with me
    to get a match on a replacement.  The old one was a different make, and
    possibly had a slightly smaller o.d. as it worked its way out of the
    hole.  The new one was a nice press fit.  It required a little
    "persuasion" to get properly seated.

    Dave, I'll have to check my receipt tonight and then I can let you know
    for sure.

    Mark St.

    Wait awhile. It will leak again :)

    Part of the problem is the current plate and the PSRU are not positively
    positioned concentrically using  dowel pins. Universal good practice
    for bolted gear boxes, bell housings and rotary engines for that
    matter.
    Larry's bell housing is going to address that problem
    as it will have a machined pilot bore for Tracy's PSRU.

    Furthermore the PSRU bore face will be positively parallel with the
    aft face
    of the engine within half a thou. Currently ANY variation in spacer
    length can
    cause this problem.
    --
    Paul Lamar ...No rotor no motor.


Paul,

I believe my name is on the list for a bellhousing.  Until then, I'll
have to make do with what I have.

BTW, the holes in my adapter plate were located and bored on a
Bridgeport with a digital readout.  Locator pins would have been a nice
addition, but I didn't think of it at the time.

Mark St.

If Larry agrees I may have some castings next week. Are you willing
to mount one, run the 3 rotor engine up to static RPM and have some people move
the tail up and down (with stops of course) to simulate gyro loads?
One foot high anchor stands for the mains would help for more angle.
I'll pay for the casting. Larry may donate the machining cost.

That is all well and good but there are other things that can go
wrong. Slop in the 10 mmm bolt holes. Bolts that don't protrude
perpendicular to the end housing. Spacers of varying lengths.
etc. Did you check the exact position of the 10 mm bolt holes
relative to the center of the end housing with a DRO?

If you have a 3" to 4" micrometer measure the exact length of all the
spacers. Errors can be accumulative in a case like this.
It is sometimes called a "stack up" of tolerances.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.