Subject: PSRU oil leak
From: Rotary Engine
Date: 6/29/2007, 10:33 AM
To: AARotary Engine



 >Can you check the seal P/N?  I'm working around a National P/N 350909
 >Thanx    Dave M

 >Dave;
 >National 350909 is correct.  My opinion is that it is a quality part.  I
 >went to NAPA and got another brand on cross reference; the National is a
 >better seal.  It is wider, and has a good spring to maintain some tension on
 >the seal.

 >Al

>Thanx Al,       Dave M

>Do you guys have a web address site for National Oil Seals?

>I found this but it is not in the range of numbers above.

>Paul Lamar

Hi Paul,      Can't help at all, I've had this seal for quite awhile
waiting for the day to use it but now that you've asked for info.....I
can't find any!  I just tried Google for National Federal-Mogul oil
seals and different combos of same. It looks like Timken (the bearing
people) may have bought National but their website is painfully slo on
dialup and showed no cross reference to the 350909 National p/n. When I
went with this seal it stated "made in the USA" which at the time the
McMaster Carr catalog page wasn't telling where their seals came from.
This seemed like an aplication where the USA logo might be worth paying
for. For those following this thread....wrap some cellophane tape around
the spline before you slide the oil seal over it and make sure you
install it in the correct orientation (sometimes the obvious is not
always obvious : )               Dave M

What diameter is the shaft?
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.