Subject: PSRU oil leak
From: Rotary Engine
Date: 6/30/2007, 4:03 PM
To: AARotary Engine



     >Can you check the seal P/N? I'm working around a National P/N  350909
     >Thanx Dave M

     >Dave;
     >National 350909 is correct. My opinion is that it is a  quality part. I
     >went to NAPA and got another brand on cross reference; the
    National is a
     >better seal. It is wider, and has a good spring to maintain some
    tension on
     >the seal.

     >Al

     >Thanx Al, Dave M

     >Do you guys have a web address site for National Oil Seals?

     >I found this but it is not in the range of numbers above.

     >Paul Lamar

    Hi Paul, Can't help at all, I've had this seal for quite awhile
    waiting for the day to use it but now that you've asked for  info.....I
    can't find any! I just tried Google for National Federal-Mogul oil
    seals and different combos of same. It looks like Timken (the  bearing
    people) may have bought National but their website is painfully  slo on
    dialup and showed no cross reference to the 350909 National p/ n. When I
    went with this seal it stated "made in the USA" which at the  time the
    McMaster Carr catalog page wasn't telling where their seals  came from.
    This seemed like an aplication where the USA logo might be  worth paying
    for. For those following this thread....wrap some cellophane  tape around
    the spline before you slide the oil seal over it and make sure you
    install it in the correct orientation (sometimes the obvious is  not
    always obvious : ) Dave M

    What diameter is the shaft?
    --
    Paul Lamar ...No rotor no motor.


    The 700R4 / 4L60 Transmission had a problem blowing the front seal
    where the converter neck enters the transmission over the input
    shaft.  This was a problem especially when pressure was  increased as
    part of the aftermarket strengthening of the transmission.

    The solution may or may not apply to the current problem.

    The oil input was for lubrication of the bushing of the turbine
    shaft neck.  The exit (drain) hole was enlarged to relieve the  built
    up  pressure.  The seal which  is enclosed in a stamped steel ring
    was coated with red locktite when installed. Finally, a  spring
    steel retainer (GM part) is installed over the seal housing.

    Joel

I mentioned this before but no response.  Why not retain the seal
with keepers.  I vaguely recall we went over this a few years ago.
The keeper could be a 360ºcollar or just a couple of tabs.   Jerry

That will work.

BTW the seal is definitely marked National S-1621 350909 and
it is one inch ID and 1.5 inch OD and .310 wide. According to this
Timken/National chart standard seals are marginal in this application
at 7000 RPM. Particularly at 220 F which might be a typical temperature
of the gear box case.

The McMaster part number for the high temp. high FPM shaft speed graphite impregnated
Teflon seal is 131295K95. Unfortunately it is only 1.25 inch OD which is not
a problem with the new bell housing but will require an adapter
for Tracy's plate.

SKF part number is 9811. Width is is .375" A bit wider. However it is Nitrile
which is marginal for this app.. Apparently .310 is not a widely available
width. .375 seems to be the standard.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.