Subject: New front cover - Question for Larry Childs
From: Rotary Engine
Date: 7/2/2007, 8:31 PM
To: AARotary Engine


Larry,
After reading that you are planning to build some specific rotary
engine parts including a new front cover I was wondering if you have
considered building this new front cover to also be an engine
mounting plate for the conical style engine mount? Mistral
(http://www.mistral-engines.com/index_files/Page710.htm) is
building ta
similar part for the dynafocal mounts but I understand that it is
very
expensive (but i don't remember how much- anyone?).

Ken Powell

Ken,
The front cover system I will have in two versions. One will be
used only on
the new aluminum front side plate, and the side plate will have
conical
mounts on it. The other cover will fit stock mazda front side
housings. Both
front covers aren't planned to have the mounts in them, but gear
driven
accessory mounts for standard spine drive components like vac pump,
alternators and air conditioning. They will also use a direct
coupled water
pump, eliminating all belts.
If enough interest is generated, a front cover with mounts in it
could be
done, just wasn't in my plans.
Larry


Larry, thanks for the reply.  I was looking for something a little
more elegant than the RV-4 mount that I had built previously (please
see the attached picture).  BTW, Paul has designed a RV-4 mount that
I like alot better than mine but mine is DONE and I'm not too keen
about building another mount unless I could just bolt the engine to
a conical type mount.

Ken Powell

C150 / RV-4 under construction



Ken,

That mount is interesting and the one that peaked my interest the most I
must say. The frame behind the mounts appears super strong. I especially
like that you brought a pipe in tension to the Bell housing end of the
engine. This is good for a static down force obviously but I'm trying to
figure out the load paths with a side to side movement or negative force
stall.  Correct me if I am wrong please but wouldn't the approx. 35 " moment
still fulcrum directly at the rear rubber mounts?

Doug



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.