Subject: [Fwd: Re: Breaktrough in all mechanical fuel injection.]
From: Rotary Engine
Date: 7/3/2007, 4:17 PM
To: AARotary Engine


Paul,
If Teflon is difficult to machine and sheets vary in thickness, why not use
an aluminum slide with Teflon buttons.
George (down under)

Because it would not seal.

Paul Lamar ...No rotor no motor.

Would spring loaded outer Al plates work?
Either a clamp around or through bolts with slotted Teflon,
where springs clamp the two Al plates at a predetermined clamping force.

Hope this was not suggested before.
Just my 2 cents.

Rolf

They might but that is not the critical problem. As you are dealing only
with a 3/8 to 1/2 inch expansion length. A few thou under thickness is not going
to hurt. The problem is the seal between the top of the Teflon and
the bottom of the top of the spacer is the critical problem. We will merely
spring load the Teflon up against this surface to seal it.

Here is a marked up 3D.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.