Subject: Latest bell housing FEA
From: Rotary Engine
Date: 7/3/2007, 4:06 PM
To: AARotary Engine


> I knew Larry could get them all down in the blue.
> Larry is now working on a weight reduction program.
> Probably just a larger radius around the out side.
> Should save about a 1/2 pound.
> > > Part of the oil seal leak problem is the current plate and the PSRU are not
> positively positioned concentrically using  dowel pins. Universal good
> practice for bolted gear boxes, bell housings and rotary engines for that
> matter.  Larry's new Rev J bell housing is going to address that problem> as it will have a machined pilot bore for Tracy's PSRU.
> > Furthermore the PSRU bore face will be positively parallel with the
> aft face  of the engine within half a thou. Currently ANY variation in spacer
> length can  cause this problem.
> > I have come to the conclusion this is the most important
> reason for a one piece bell housing.
> > > We will have the patterns any day now so I can get them
> in the foundry.
> > Paul Lamar ...No rotor no motor.

Paul, Larry,

I am extremely happy to see those external and internal ribs in the housing.
Good going.  One question.  What is the internal depth dimension?

Doug Fir

As I recall it is 3.050"

Paul Lamar ...No rotor no motor.

It's 3.50" outside w/ a 0.20" wall leaving it 3.30" deep inside from the flange.

Jarrett

Jarrett did the conversion from a Rhino file to a Solid Works file.

Larry changed it so we will have to get the latest dwg IGES from Larry.
I agree on the outside dim but the inside is supposed to
have a .3 inch reinforcing ring where Tracy's bolt circle and
where the shaft seal is mounted.

When you have three highly creative guys with compatible 3D programs sharing files
the permutations and variations explode exponentially :)

Maybe we better wait until we have one machined :)
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.