Subject: megasquirt: It's ALIVE!!]
From: Rotary Engine
Date: 7/3/2007, 10:46 AM
To: AARotary Engine


> I'm doing a 48hr burn in on the Megasquirt I just finished putting
> together.  The display is the Megaview, and the circuit board sticking
> out the back with the knob is the Stimulator, which provides inputs for
> testing.
>
> The display scrolls engine parameters from right to left, and the second
> button toggles static mode so that the display stops.  The display's
> buttons can also be used to change engine parameters, but this appears
> to be an exceedingly tedious process.  Much better to use the Megatune
> software that runs on a PC or PalmPilot.
>
> I should have taken pictures before closing up the box.  Oh well, I'll
> have to have it back open before too long anyway.  The current state
> reminds me of why they load down computers with blinking lights and
> dials in the movies.  They're just plain boring in their natural state.
>
> Ernest

Ernest,

Great going. Does Megatune have any data recording and visual display
functions.  It would be nice in that we could make our own dyno as well as
our own graphic engine parameter display device using a small monitor.

Doug in Japan


http://www.megamanual.com/v22manual/mtune.htm
Ernest


Is that a  MegaSquirt-I: (68HC908) you built?


BTW http://ernest.isa-geek.org/

"The picture below shows a very favorable location for the radiator. The plan is
to pick up air out of the wheel wells and dump it out over the elevon hinge points.
Fifteen feet of 5/8x.028 aluminum tubing to move the water to the back will cost me
about 5lbs, which will be partially recovered by the elimination of a coolant reservoir.
Basically, the pipe will be the reservoir -- a long, thin one that will aid in cooling
if I can duct air to it. An electric water pump placed next to the radiator is another
opportunity to move weight aft, as well as shedding about ten pounds.
 I'm also considering installing the oil cooler behind the firewall at the right inboard
wing strake. A pickup will provide cabin heat. I find this more comfortable than a heat
muff or using engine coolant."

Not a bad place to put the rad. The P51 had it back there.  I don't think using
the wheel wells alone will gather enough air. You will probably need a P51 type scoop.

You might want to read my book.  http://www.rotaryeng.net/how-to-cool12.html

I did a few Dyke Delta layouts awhile back. There is not a lot of room under
the cowl for intakes.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.