Subject: Breaktrough in all mechanical fuel injection.
From: Rotary Engine
Date: 7/4/2007, 6:28 AM
To: AARotary Engine



>> Paul,
>> If Teflon is difficult to machine and sheets vary in thickness, why
>> not use
>> an aluminum slide with Teflon buttons.
>> George (down under)
>>
>> Because it would not seal.
>>
>> Paul Lamar ...No rotor no motor.

Would spring loaded outer Al plates work?
Either a clamp around or through bolts with slotted Teflon,
where springs clamp the two Al plates at a predetermined clamping force.

Hope this was not suggested before.
Just my 2 cents.

Rolf

They might but that is not the critical problem. As you are dealing only
with a 3/8 to 1/2 inch expansion length. A few thou under thickness is not
going
to hurt. The problem is the seal between the top of the Teflon and
the bottom of the top of the spacer is the critical problem. We will
merely
spring load the Teflon up against this surface to seal it.

Here is a marked up 3D.

Paul Lamar ...No rotor no motor.




Would it be possible to machine the teflon slide so those areas where the
ramps are could protrude through the top of the spacer and be sealed on the
top with an AL cap? Just a thought.

Joe Berki
Limo EZ
Waiting for teflon slide

***************************************************************
I don't think there is room to do that around the bolts.

Here is my latest thinking on the idea.

Unfortunately we have to worry
about wear and the 5 psi or more fuel pressure tending to separate
the Teflon from the upper bottom surface of the spacer. Not just thermal
expansion.

I see no way around some sort of springs that apply at least
30 pounds of force to the bottom of the slide. Slide is 12" long by .5 inches
wide which is 6 square inches. Therefore times 5 psi is 30 pounds of force.
Therefore the throttle cable force is increased by 1.8 pounds.

Here is a die spring solution. Set screws (not shown) can adjust
the force. Cheaper than a 7075 T6 spacer and it is adjustable
to compensate for wear.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.