Subject: Breaktrough in all mechanical fuel injection.
From: Rotary Engine
Date: 7/4/2007, 9:23 PM
To: AARotary Engine


Paul,
If Teflon is difficult to machine and sheets vary in thickness, why not use
an aluminum slide with Teflon buttons.
George (down under)

Because it would not seal.

Paul Lamar ...No rotor no motor.

It would with Teflon o-rings around the holes instead of buttons, wouldn't
it? Of course, we would have to remember that which we learned in olden
times using Teflon on the end of Chevy v8 wrist pins, that stuff expands
more than most other stuff; so, just couldn't make it too tight a fit or
wouldn't slide when got hot.

jofarr, soddy tn

What happens when the slide moves over part of the large hole?
What keeps the O-ring in its slot?

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.