Subject: Castor Oil Was: Synth Blend... M/C or HDEO in Airborne Rotaries
From: Rotary Engine
Date: 7/4/2007, 9:29 PM
To: AARotary Engine


I might add here, in my 50 years of competition model airplanes, I've
discovered that pure castor oil will run cooler. It also is good for 1000
rpm on my competition engines. These engines run around 30,000 rpm. I
personally run 18% synthetic and 4% castor just because of the mess, but
castor seems to be s superior lubricant!

Bob M

Castor oil breaks down to form heavier fluids that provide excellent
lubrication in extremely high temperatures and RPMs.  The synthetic oil is
performing better at the lower RPMs as the castor is heating and breaking
down.  This is a niche application that really shows the oil's strengths.
There are enough negatives that make it unsuitable for most other users,
though.

From one cart racer website:
"But alas, the report on castor oil as a 2 cycle lubricant isn't all good.
Some of the gums and other components that Mother Nature put in the castor
bean don't burn all that well and they can leave a gooey mess behind that
can make piston rings stick in their grooves. And the parts that do burn can
leave behind a significant amount of carbon on the piston crown and the
inside of the head. Virtually all of today's castor-based 2 cycle oils as
described as being "de-gummed" but that is really a relative term. They have
less gum and leave less carbon than their non-de-gummed cousins, but it is
still something the user needs to be aware of. One other negative you need
to be aware of is that castor-based oils have a disturbing tendency to
"fall" out of solution in gasoline when they get below 50 degrees or so.
More than one dirt racer has had the unhappy experience of finding all the
castor oil pooled in the bottom of his fuel tank or in the bottom of the
fuel jug when the nighttime temperature has dropped. This is not an "every
time" thing and that may have to do with the various additives in addition
to the castor oil in the oil bottle. But it is a significant consideration
if your racing might include some cold days or nights."
http://www.foxvalleykart.com/oil1.html

Later, about synthetics, the author writes:
"The cleaner burning properties of these synthetics mean that the ritual
cleaning of pistons and rings that is part of the castor- based world is a
thing of the past. Synthetic oil users also are spared the daily hassle of
scrapping built-up carbon from the piston crown and the combustion chamber
just to ensure passing the cc test in post-race tech."

Here's a quote from an SAE pub, "History of Aircraft Lubricants":
"...Bass also recalled a visit in Berlin with the Lufthansa chief engineer,
about 1935.  Lufthansa still had some Mercedes engines flying in
single-engine Junkers mail planes.  These engines were running on castor
oil.  The crankcases on these six-cylinder in-line engines distorted so much
that oil loss on mineral oil was unacceptable.  After a few hours of
operation on castor oil, the oxidized residues in the crankcase sealed the
leaks."

Andy


I agree. I used to race two strokes engines in motocross. Castor was
very good at lubricating but it was a pain to clean the combustion
chamber, piston crowns and piston rings grooves.

Alfonso


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.