Paul here is a drawing of the stock CH 701 engine mount hard points
on the firewall. I am also sending a couple of scans from the plans
which show a Rotax engine mount. They show the leaned back firewall.
The angle is 107 degrees. I intend to run the p port intake to
the left nostril. I don't have a firewall to prop flange distance
since I don't know what redrive will be used. Can you draw it with
6 inches of space between the water pump pulley and the firewall?
Can the upper hard point be used for a strut?
Also, I am concerned about the doubly shortened oil pan (one rotor
plus S-beam notch ) How would you plumb an additional tank firewall
mounted?
Thanks in advance. Jerry
Sure.
--
Couple of questions. How far up from the bottom of the firewall
are the lower hard points?
How long is the cowl from firewall to prop flange?
Paul Lamar ...No rotor no motor.
For the Rotax the prop flange to firewall is 760 mm (approx 30 in)
and from the bottom of the firewall to the lower points is 1.5 in.
Prop flange distance is not critical as I will make my own aluminum
cowl.
Jerry Hey
Well if you can cut it down to 20 inches or so you can save some weight
in the PSRU by making it shorter. That will help the weight and balance
as I can move the engine back closer to the firewall.
What do you think of the home made PSRU so far?
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.