Paul, here is the last bit of data.  The prop flange to firewall is
37.5 inches.    For my purposes, can you draw the engine mount
without the thrust off sets?   Thanks,  Jerry

OK
-- 
-----------------------------------------------------

Here it is. Asymmetrical for those that would like to put the
rad on the side.

-- 
Paul Lamar ...No rotor no motor.

Hi guy's
I have been reading you for a couple of weeks and this last arrangement is
close to what I was thinking for my airplane.I am building a BearHawk
Patrol. I intend to put the rad on the side, the oil cooler (RX-7)on the
bottom with the air intake close to were normaly the carb intake would be
and the intake manifold would be about the same as your drawing with the air
intake from the left of the cowling were you show the oil cooler. The nose
cowl would be close to that of a Pitts. Wondering what it would look like. I
have an adaptor plate from conversionconcepts and a RD-1C gear reduction
drive.
Raymond Lambert


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.