Paul,  can you give me the measurements from center to Barry center
for the asymmetrical  S beam.  Dale has decided to go with the cool
side radiator.    Jerry

Sure :)

--  Paul Lamar ...No rotor no motor.

Thanks,

Jerry AKA Paul :)

Is there some reason you guys are not signing your messages? :)

Paul Lamar

The hot side  stock S-Beam from beam center to Barry center is 14.5
inches.    Did you want to shorten it for some reason?   I am going
to do a trial set up, to make sure the fixture is not in way of the
lower diagonal on the cool side.     If it is not possible, I will
let you know what is. It is hard to make a fixture for a product that
changes dimensions in every iteration. :)   Jerry

OK just move it out to 14.5" from 13.28"

I think you ought to make this variable as airplanes are different widths.
You have to change the cool side length for side mounted rads anyway.

Have you made up a bunch of s-beams with the holes in the webs?
The hole positions relative to the bushing aluminum support plates and loads
is critical. In other words can I put the holes anywhere I want?

While I have you on the line what do you think of moving the rear rubber
bushing down near the bottom of the oil pan? I have an idea that could simplify
the entire mount. This part would become higher or longer.

Do you have a band saw?