Subject: single rotor belt drive
From: Rotary Engine
Date: 7/10/2007, 7:54 AM
To: AARotary Engine <rotaryeng@earthlink.net>, Ken Welter <rotarycoot.ken@gmail.com>


Assuming that there would be a bearing  on the prop side of the drive
sprocket (not always the case in low hp drives)  center alignment is
the issue for me.   What would the tolerance be?  Is there any type
of coupler that is self aligning?  I have searched the Internet for
Belt PSRU plans but so far no luck.  If someone has a drawing they
would be willing to share,  I would like to see it.

   I looked at Gates web site. It is huge and I need to explore it
further but I saw no belts rated for more than 5500 rpm output.    I
am looking for output   in the 6000 to 7000 rpm range.  Does the high
rpm of the rotary lobby against against a belt drive?
Jerry

The guy with the most experience in belt drives on the rotary is Ken Welter.
Why reinvent the wheel? Ken has 100's of hours on his design. If he does
not have dwgs I will redraw it from his dimensions and bearing part numbers.
The technical risk is minimal.

Gates's belt ratings are conservative and Ken is running his engine well
over 5500 RPM.

Ken Welter <rotarycoot.ken@gmail.com>

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.