Subject: Prop diameter, pitch, rpm??????]
From: Rotary Engine
Date: 7/12/2007, 12:02 PM
To: AARotary Engine



I did look briefly on the internet but did not find clarity.  Perhaps
I should look harder....anyway, here is the problem:  Some of the LSA
engine prop combinations use quite short props, much shorter than I
am used to.    Could some one tell me the tip speed of a sixty inch
diameter prop turning   3400 rpm.
 Jerry-------- Forever humiliated to be so weak mathematically.

That is because of VW and the Jabiru, a close relative of the VW,
are rated at 3300 RPM. You are building an STOL. You need the
largest diameter prop you can get on there.
-- 
BTW Harley rear pulleys are under $100 new. They are up to 1.5" wide
and up to 72 teeth and you can stack two or more side by side and use multiple  $169
belts. There is a bunch on e-bay.

http://www.tejasthumpcycles.com/Parts/primaryclutch/harley_belt_drives.htm

Download this catalog. http://www.sudco.com/


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.