Subject: Prop diameter, pitch, rpm??????
From: Rotary Engine
Date: 7/12/2007, 1:02 PM
To: AARotary Engine


I did look briefly on the internet but did not find clarity.  Perhaps
I should look harder....anyway, here is the problem:  Some of the LSA
engine prop combinations use quite short props, much shorter than I
am used to.    Could some one tell me the tip speed of a sixty inch
diameter prop turning   3400 rpm.
Jerry


Go to www.warpdrive.com (not actually the prop company, but a major
distributor).  They have a link to an online prop speed/rpm/diameter
calculator.

Keith



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.