Subject: Prop diameter, pitch, rpm??????
From: Rotary Engine
Date: 7/12/2007, 2:52 PM
To: AARotary Engine


I did look briefly on the internet but did not find clarity.  Perhaps
I should look harder....anyway, here is the problem:  Some of the LSA
engine prop combinations use quite short props, much shorter than I
am used to.    Could some one tell me the tip speed of a sixty inch
diameter prop turning   3400 rpm.
  Jerry-------- Forever humiliated to be so weak mathematically.

That is because of VW and the Jabiru, a close relative of the VW,
are rated at 3300 RPM. You are building an STOL. You need the
largest diameter prop you can get on there.
-- 
BTW Harley rear pulleys are under $100 new. They are up to 1.5" wide
and up to 72 teeth and you can stack two or more side by side and use multiple  $169
belts. There is a bunch on e-bay.

http://www.tejasthumpcycles.com/Parts/primaryclutch/harley_belt_drives.htm

Download this catalog. http://www.sudco.com/


Paul Lamar ...No rotor no motor.

Jerry, just to give you an idea of the what you may have to look for.
I have on my Heavy Hauler  AVID a 75" three blade Powerfin, driven by a SOOB
100hp through a 1 : 2.62 Rotax C-box. I am happy with performance in every
respect. Even with that slow running prop. I can still cruise at 100mph with
the engine running in the upper 4k. It is not noisy too.
This experience is the reason why I am using the 3.3 : 1 ratio on the single
rotor.
When I built the AVID and settled on the SOOB with the C-box, the only prop
I found over 72" dia was Powerfin. Idealy it should have been 76", but
Powerfin could not do it, so I settled on 75". My estimates gave me a pitch
angle of 13deg at the tip, and that is what I am still flying.
Dont forget, "slow airplane = slow and large prop" means good prop
efficiency.
I hope this helps.

Richard Sohn
N2071U


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.