Subject: Prop diameter, pitch, rpm??????
From: Rotary Engine
Date: 7/12/2007, 6:22 PM
To: AARotary Engine


> I did look briefly on the internet but did not
find clarity.aribian  Perhaps
> I should look harder....anyway, here is the
problem:  Some of the LSA
> engine prop combinations use quite short props,
much shorter than I
> am used to.    Could some one tell me the tip
speed of a sixty inch
> diameter prop turning   3400 rpm.
 > Jerry
Go to www.warpdrive.com (not actually the prop
company, but a major
distributor).  They have a link to an online prop
speed/rpm/diameter
calculator.
Keith

C = Pi x D.   Karibian

Thank you.  That will do the job.  Jerry


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.