Subject: aluminum end plates
From: Rotary Engine
Date: 7/12/2007, 5:46 AM
To: AARotary Engine


From: Dave Arbogast, Sent: Wednesday, July 11, 2007 9:44 AM
To: jlanger@racingbeat.com
Subject: aluminum end plates

I need build an all aluminum single rotor. I understand you have  aluminum end plates...  Do you ?  How much?

-dave



Thanks Jim - what is the price for the front aluminum housing? I  see the
$1425.00 for the rear.

-dave

Jim Langer wrote:

>Yes we offer these units, however they are not inexpensive. You  can see them
>at:
>
>www.racingbeat.com/resultset.asp?partnumber=11051
>www.racingbeat.com/resultset.asp?partnumber=11071
>
>
>
>Best regards,
>
>Jim Langer
>Racing Beat, Inc.
>714-779-8677
>Fax 714-779-2902
>www.racingbeat.com

$1425.00 for each end plate plus 1500.00 for eccentric set up from
Atkins and $150.00 for tension bolts comes to $4500.00 for an off the
shelf single rotor.  This compares favorably with Rotax and provides
the power to weight ratio the single rotor needs for LSA.

Still needed is a 20-30lb drive.   For this engine,  120 hp
would be the max.  Can a lighter belt drive  be built?  For example,
copying Ken's drive, could .375" thick plates be substituted for the.
5 he used?  Can we use lightening holes and/or pockets in the
plates?  Aluminum drive sprocket?   Ken has warned against using a
narrower belt,  too bad, because those wide sprockets, are heavy and
expensive.    Jerry



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.