>> Oh; yeah. I also tried VGs about 2 1/2 ft in front of the exit
>> fairing --
>> no noticeable effect. I had previously tried smaller VGs on top of the
>> exit
>> fairing for no joy.
>>
>> Al
>
> Hey Al,
>
> I think there's likely separation as illustrated in the first picture.
>
> I think Paul is right about the wedge diffuser, but I don't think you
> have
> to move the cooler to the cowl. Maybe have a look at the 2nd pic...
>
> What do you think?
>
>
> Matt-
You need to read my book Ernest.
You can get it from Aircraft Spruce
http://www.rotaryeng.net/how-to-cool12.html
http://www.aircraftspruce.com/catalog/bvpages/coolYourWankel.php
--
Paul Lamar ...No rotor no motor.
Here is a better way of dealing with the boundary layer Al.
This is from Hoerner Fluid Dynamic Drag.
--
Paul Lamar ...No rotor no motor.
Hmm.. Some of that page you scanned from HFD was not intuitive to me.. I
still have lots to learn about aerodynamics. :)
Do you know what the units are on the plot? Is that Pressure vs. Velocity?
Or pressure vs position? I gather that the line without the slot (*) is
less efficient somehow..
Matt-
The squiggly vertical line is the greek letter zeta universally used to denote efficiency.
This is the left vertical y axis. In this case Hoerner calls it a loss coefficient.
The X axis is the ratio of flow through the core "w"over the free stream velocity "V".
When this is a very small number the chart shows the cooling efficiency is very low.
Obviously the rad is very thick or the fins and tubes are too close together.
This is a function of the porosity of the core or the drag of the core.
Modern heat exchangers are large frontal area with low porosity.
This of course is not the whole story as one needs to know how the heat exchanger
dissipates heat as a function of the porosity of the core and flow through the core.
Heating the air adds energy to it so if this can be squirted aft that will
tend to offset the drag.
The Reynolds number is R sub c is 6 to the 10 superscript 6.
The lift coefficient for the wing C sub l is .3
I am not sure what little s means.
C is the cord of the section and is equal 1.28 meters.
S sub square is the frontal area of the core and it is .65 square feet in this case.
The main reason you want a boundary layer bypass is to get more mass flow
into the duct and through the core. Ingesting the low velocity boundary layer
is bad news.
BTW Hoerner signed my copy in 1965 and Klaus used to date his daughter :)
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.