Subject: Oil cooler air flow
From: Rotary Engine
Date: 7/14/2007, 4:32 PM
To: AARotary Engine


Joel,
We run the cooler on the scavage side, so the pressure is very low. We have
run 100 psi on the cooler with air on diesels and this one was leak checked
at 105 PSI.
They rate them at 300 psi, I just haven't had the guts to take one there.
One of the suppliers I use now also has liquid to air cores, just didn't
have the monster size I needed for the P&W R2000.
Larry


-----Original Message-----
From: Rotary Engine [mailto:rotaryeng@earthlink.net]
Sent: Saturday, July 14, 2007 12:46 PM
To: AARotary Engine
Subject: Oil cooler air flow


Al,
I vote for any form of scoop (ala P-51) that is moved far enough off the
surface to get out of the boundary layer. Ingesting boundary layer air is
never efficient regardless of how cosmetic it is. As an alternative, you
oversize the heck out of the cooler and get away with passing less air over
it. That is the direction we took on the Yak, and now the oil temp runs on
the thermostat setting with the cooler doors closed. We did this for speed,
as reducing the air through the cooler reduces drag. Cooler is home made
unit custom fit to replace 2 10" diameter x 10" long tube type coolers. The
tube coolers were never efficient regardless of how much air we flowed
through them.
Larry

Larry,
How did you make those radiators?
George ( down under)


George,
The core is a racing air to air intercooler core, and the tanks and
manifolds designed, machined and welded in house. The manifolds are
conventional 2d machining and the end tanks are 3d machined out of billet.
It uses a standard aircraft style bypass thermostat.
Larry


  Larry,
  Looking at the end of the core, the passage channels appear to be the
thickness of
the core with vertical  fins running  thru each passage from side to side.
As the core
was originally an air to air intercooler which is a relatively low pressure
heat exchanger,
what pressures have you tested it for?

  Joel

Joel,
We run the cooler on the scavage side, so the pressure is very low. We have
run 100 psi on the cooler with air on diesels and this one was leak checked
at 105 PSI.
They rate them at 300 psi, I just haven't had the guts to take one there.
One of the suppliers I use now also has liquid to air cores, just didn't
have the monster size I needed for the P&W R2000.
Larry



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.