Subject: Prop diameter, pitch, rpm??????
From: Rotary Engine
Date: 7/14/2007, 6:23 AM
To: AARotary Engine


Guys,
The calculations on hoverhawk will will give you the tip speed with the
aircraft tied down to the ground. Tip speed in flight is influenced greatly
by TAS. Attached is a spread sheet to allow you to calculate your top mach
numbers based on engine rpm, gear ratio, prop diameter, and TAS.
This will give you a better idea what your tip is doing at what airspeed.
Larry

>>> I did look briefly on the internet but did not find clarity.  Perhaps
>>> I should look harder....anyway, here is the problem:  Some of the LSA
>>> engine prop combinations use quite short props, much shorter than I
>>> am used to.    Could some one tell me the tip speed of a sixty inch
>>> diameter prop turning   3400 rpm.
>>
>> > Jerry
>>
>>
>> Go to www.warpdrive.com (not actually the prop company, but a major
>> distributor).  They have a link to an online prop speed/rpm/diameter
>> calculator.
>>
>> Keith
> > The link doesn't work for me..  any one else?
> > -dave

My error, it's www.warpdriveprops.com, but the actual tip speed
calculator is at http://www.hoverhawk.com/propspd.html

Keith

Guys,
The calculations on hoverhawk will will give you the tip speed with the
aircraft tied down to the ground. Tip speed in flight is influenced greatly
by TAS. Attached is a spread sheet to allow you to calculate your top mach
numbers based on engine rpm, gear ratio, prop diameter, and TAS.
This will give you a better idea what your tip is doing at what airspeed.
Larry


There is a very useful constant which can be used as a guide for these calculations.
It simply relates prop revs to diameter at about 0.72 Mach.
The constant is 201,655. Thus if a Prop is to run up to 2,700 rpm it is divided
into the constant to recommend 74.6 inches as the maximum diameter of a prop.
After that the tips approach transonic speeds and just create drag and noise.
Of course the calculation works in reverse as well.
Thinner tips and sweep back give a little lattituide for slightly higher speeds.

John Evans

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.