Hi All-

Now that I have my newly-updated EC2 and EM2 back in place, I wanted to
wire
in the O2 sensor to enable auto-tuning mode before I try for a startup
again.  The suggested O2 sensor, unfortunately, requires a 18mmx1.5
thread.

A tough tap to find.  Worse, it requires a 16.5mm pre-drill -- even
harder
to find.

Anyone have any suggestions on how to get my hands on either/both of
these
without spending an arm & a leg?

Mark (Rocky mtn high)

The company at this web site has an oxygen sensor bung (18mmx1.5 thread)
for $7.00.  You can weld it on your exhaust pipe or header.  See
http://www.zeitronix.com/order/order.htm


Bob Rogers


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.