Paul,

Some time ago you did a 3d of the 9A FWF with side cooling. I have  been unable to find a radiator of the correct size to fit under the  engine - there are lots of 21X19 but no 21X17. The 21X19 just won't  fit no matter which way you turn it. There is a 13" but it is 3"  thick, and very pricey.

If you still have that 3D around could you please send it to me?  Thanks.

I think someone mentioned that a stock Van's cowl could be used  with side cooling. So does anybody have the dimensions?

Thanks in advance.

Doc Custer
Retired Software Engineer and sometime Audiologist

I'll dig it up later today Doc. Got to go down to Mazdatrix and  pick up
my RX8 engine rotor housings and get them in the shop to be bored for
the P-port.
-- 
Paul Lamar ...No rotor no motor.

Doc,  try C &R for the 13 x 21 Schiracco (sp?)  race rad.   It is two
1 inch cores with a 5/8" space between.   I did not think it was too
expensive at the time but that was two years ago.  I don't what they
would be charging today.  Jerry


Doc I can set it up so you can download and IGES on this if you wish.