Subject: Oil cooler air flow
From: Rotary Engine
Date: 7/19/2007, 3:25 AM
To: AARotary Engine


I think the core is acting like a true radiator doing what little oil
cooling you are getting.

-- 
Paul Lamar ...No rotor no motor.
------------------

Based on the temp drop of the oil, and the temp increase in the air; I am
currently getting 950 - 1000 CFM air flow through the core @ 160 mph.  Even
assuming an emissivity of 0.8; my calcs show that radiation heat transfer at
200F to be negligible - even if it wasn't in an enclosure.

Al



Lots of room heaters work this way. No fan. Convection currents only.

1000 CFM at one square foot oil cooler frontal area is 1000 FPM or 16 FPS or
11 MPH
air speed through the core. Sounds like convection currents to me.

Paul Lamar ...No rotor no motor.
-------------------

The cooler core area is 0.67 ft sq., velocity through the core is about 16
mph.  Natural convection is what I get on the ground - pretty close to zero.

Average velocity into the scoop entrance is about 55 - 60 mph

Al

How do you know? I did not see any pictures of pito tubes inside the
entrance. If so not much for 160 MPH forward speed.

At a forward speed of 80 MPH we were getting 24 MPH more or less evenly
distributed  across the back surface  of the core with this wedge diffuser.
-- 
Paul Lamar ...No rotor no motor.
---------------

Well; I know because I know I have about 1000 CFM, and I know the area of
the inlet scoop.  Note I said 'average' velocity.

True; it is clearly not much for 160 mph.

Yes, but see, I don't HAVE a wedge diffuser.  What I have is what I have;
and the first task at hand is to see if there is some reasonable way to make
it work.  As soon as I find some time, and get to the airport I can try some
things.
Al


Well Al let us know what you come up with. I am all out of suggestions.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.