I have decided to make a simple carb for those people that
don't want to deal with EFI. It is a real shame that one needs
a degree in electrical engineering to tune and install current EFI products.
Anybody can understand a carb. The leaning system uses an eccentric shaft
just like the rotary to change the float level. Super simple.
I stole an idea from Weber carbs. There will be two small venturis
that do the fuel metering. Can't beat a simple system like that.
Internal fuel passages are not shown yet for the most part.
Hopefully Larry will build it and sell it. I am sure he will have
a lot of suggestions for improvements.
This carb works with Doc's slide throttle as is. It is merely bolted
to the side of the slide throttle.
This is a low technical risk solution. Guaranteed to work right
out of the box. No innovation here.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.