> All,
>
> http://www.geareddrives.com/Buds_philosophy.htm
> Has a nice write up in the last Contact mag. I like the features of his
> psru----cs, separate lube, clutch arrangement as he did it, offset shaft.
>
> He says "*Build the PSRU so that anyone would be feel good about taking
> their grandchildren on a cross country flight.* Safety being our first
> consideration, we do not advocate the use of belts, chains or planetary
> gears in something as important as a propeller drive. Belts break,
> chains stretch, and planetary gears are simply not designed to operate
> at high RPM's and under such a great load as they are under while in use
> in an airplane. Planetary gears do well in situations that only require
> high RPM for a very brief period of time, but are not designed to
> operate under consistent and continuous use at high RPMs. This is a
> recipe for disaster in our opinion. Spur gears, as we use in our PSRU,
> on the other hand, are designed to safely operate at a high RPMs and
> under continuously use. We chose to use what we know to be the most
> dependable and reliable technology for this application because our
> objective was to do what makes sense in terms of safety, reliability,
> and ease of maintenance. "
>
> Erstwhile comments on the planetary? What do you think Mistral makes of
> this? Of course his re drives are mostly made for V8's but I really like
> the clutch feature as he implements it!
>
>
>
> Marc Wiese
>
>
> I talked to these people at OSH and they don't have a clue. The centrifugal clutch
> is nice. Also the yearly Chev V8 conversion. Here this year gone the next.
>
> --
> Paul Lamar ...No rotor no motor.
I also spoke with Bud at OSH and I believe his words were "I'm not interested in that" when
I asked him about a 3:1 ratio. As Paul mentioned, his interest is only for recip auto
conversions, he does have 700hrs on his 383ci SBC however. His price is up there too at
around $9k. At that point I would just use the Mistral PSRU. Personally, I don't understand
the concern about planetary gears that are designed properly....heck, pretty much all turbo
props use planetary gear sets as far as I know, and if a turboprop isn't high rpm, then I
don't know what is...
By the way Paul, I looked for you at the "Design Of Water Cooled Aircraft Cooling System."
I figured you would show up at that forum and I wanted to meet you in person, oh well,
maybe next time....
Heath
Sorry I missed you.
I usually don't do the forums. How did that one go? Who was the speaker?
Any interesting tid bits you can share.
--
Paul Lamar ...No rotor no motor.
The presenter was Timothy Shankland and it was pretty good.... I only made about half
of it and when I showed up he was going through some heat transfer equations to
calculate cooling efficiency and how big of a radiator is required for a given engine.
I didn't take notes, but it seamed like pretty standard stuff. His engine of choice
was a Subaru.
It turns out he had a similar test setup as you did where he strapped a test fixture
to his station wagon and hooked up a manometer to determine the best ducting configuration.
Heath
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.