Subject: Dual horzontal carb
From: Rotary Engine
Date: 7/31/2007, 5:45 AM
To: AARotary Engine



I have decided to make a simple carb for those people that
don't want to deal with EFI. It is a real shame that one needs
a degree in electrical engineering to tune and install current EFI  products.
Anybody can understand a carb. The leaning system uses an eccentric  shaft
just like the rotary to change the float level. Super simple.

I stole an idea from Weber carbs. There will be two small venturis
that do the fuel metering. Can't beat a simple system like that.
Internal fuel passages are not shown yet for the most part.

Hopefully Larry will build it and sell it. I am sure he will have
a lot of suggestions for improvements.

This carb works with Doc's slide throttle as is. It is merely bolted
to the side of the slide throttle.

This is a low technical risk solution. Guaranteed to work right
out of the box. No innovation here.

Paul Lamar ...No rotor no motor.

Excellent idea.  Add a simple crank trigger ignition.   Forget the
computer.     Jerry

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.