Subject: Dual horzontal carb
From: Rotary Engine
Date: 7/31/2007, 7:42 AM
To: AARotary Engine


I have decided to make a simple carb for those people that
don't want to deal with EFI. It is a real shame that one needs
a degree in electrical engineering to tune and install current EFI  products.
Anybody can understand a carb. The leaning system uses an eccentric  shaft
just like the rotary to change the float level. Super simple.

I stole an idea from Weber carbs. There will be two small venturis
that do the fuel metering. Can't beat a simple system like that.
Internal fuel passages are not shown yet for the most part.

Hopefully Larry will build it and sell it. I am sure he will have
a lot of suggestions for improvements.

This carb works with Doc's slide throttle as is. It is merely bolted
to the side of the slide throttle.

This is a low technical risk solution. Guaranteed to work right
out of the box. No innovation here.

Paul Lamar ...No rotor no motor.


Excellent idea.  Add a simple crank trigger ignition.   Forget the
computer.     Jerry

Anybody ever heard of a Fish Carburetor?  I stumbled across them while
reading
old BD-4 newletters, a builder years ago flew his -4 with one from WA to
OSH,
so I'm assuming they actually work.  Unfortunately, they seem to have
gotten
buried in the 100-mpg urban lore, but once you get past that nonsense,
they really
do appear to be a better carb, by about 30% (mpg, according to Ford).  I
haven't
had time to really research them, so reader beware.

Bob V

I looked into them but they are too small and no leaning.
You need two throats that are at least 1.875" in diameter.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.