What is an Aero Carb?
--  Paul Lamar ...No rotor no motor.

Aero Carb.  Check it out at http://www.aeroconversions.com   It will
be too small for you as the max throttle plate is 38mm.   Revmaster
makes a similar carb that goes up to 40mm.    Only $320.00. http://
www.revmasteraviation.com/products/revflow_injector_carburetor  Both
are slide throttles with mix control.  Resistant to icing, mount in
any attitude.  Jerry

***** Hi Paul and Readers
Revmaster, as of last week, their biggest "Revflow Injector Carbs is 42
mm  for $380.
Revmaster are located in Hesperia CA.
BR, Dave McC

Still not big enough. Radius squared. Over 100 HP is very important
in a one rotor. If you don't get over 100 HP per rotor why bother.

Paul Lamar ...No rotor no motor.

Paul,
What do you mean by radius squared ?
Can you tell me again how to work out the BSFC numbers e.g. .45, .5 etc.
George (down under)

The area of a circle is Pi x Radius^2 To Generate 100 HP in a p-port
engine you will need at least 1.76 square inches per rotor intake pipe area.
That is an intake pipe diameter close to 50 mm. The pipe also must be the
correct length.

BSFC is pounds of fuel burned for each HP generated in one hour. There are six pounds
in a gallon. If you are burning 10 gallons an hour you are burning
60 pounds of fuel per hour. If you are making 150 HP that is a BSFC of 60/150 or .4

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.