I woke up this morning and it hit me. How to add the benefits of injected air
to the fuel passages after the adjustable main jets. It is easy.
A couple of brass tubes with holes in them and a couple of short
pieces of red rubber hose to pick up dynamic pressure. Plus a few more holes
drilled in the carb body. I hope Larry has a tool changer :)
These are in addition to the lower tubes that add air pressure to the back side of
the diaphragm to enhance its sensing functions. It is necessary to separate
these two circuits as the back side of the diaphragm is a dead end that maintains
dynamic pressure. These tubes on the other hand actually flow air.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.