In theory this is all you need along with four Continental type
injectors. It functions almost exactly like my new carb design.
The hose barb on the right is connected to the intake
manifold behind the slide throttle. The regulated pressure
increase with intake manifold pressure increases.
How much it changes is a subject of an email question I sent
to TWM.
If it increases 15 psi as the manifold pressure increase 15 psi
we are home free. The only real fly in the ointment is
it does not start at zero pressure. I'll have to give that
some thought.
The problem is leaning the engine as this pressure regulator
has a screw to set the mixture rather than a lever.
However it could be mounted on the instrument panel
with a knob that you turn.
You start the engine the same way. Turn the engine over with the
starter and then turn on the fuel pump. The accelerator pump
is the same device that I use. A pancake air cylinder mounted
on the throttle knob will send a shot of high pressure air
to the regulator temporarily increasing the mixture. This device
can also be used for starting the engine.
---------------------------------------
Here is another one with distinct possibilities.
They are in my neck of the woods. I think I will
stop in tomorrow and talk it over with them.
Paul Lamar ...No rotor no motor.
Paul,
If you want one, I have the prochargers version of the same thing. They work
by restricting the return line to the tank to raise fuel pressure under
boost. I will have your housing welded this weekend and I can pack it with
the housing.
These were used to keep from having to buy fuel injectors when installing
low boost blowers. They were marginal at best for the engine I ran it on,
but may be tuned to work well for what we are doing.
Larry
Thanks Larry. Please send it with the housing. I am not totally convinced
it will work as a low cost injection system but I have to explore
all possibilities. If something works off the shelf there is no point in
reinventing the wheel as George Lazik suggest.
I like the idea of having everything, including the necessary
trumpet mouths all in one block of aluminum. No external fuel plumbing
and no over priced aircraft injectors. Two 2 inch diameter trumpet
mouths alone are not free. Also one must kludge up some practical
way to turn the pressure regulator adjusting screw from the cockpit
for leaning purposes.
I am working on the leaning eccentric shaft design as we speak. No easy task
when you are dealing with 60 pound forces on the spring. I am
thinking of using needle bearings for the shaft and the eccentric.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.