No longer a real carb. Mostly mechanical
fuel injections based on fuel pressure regulator design. Features:

1) One inch thick.
2) Two adjustable air injected fuel ports. One for each runner.
3) Two adjustable main jets.
4) Two bell or trumpet mouths. (Worth 5% more power.)
5) Built in pressure regulator. The pressure regulator is the injection system.
6) Mounts on the end of the runners with simple clamps. (Detail not shown.)
7) Fuel pressure port for mechanical gauge. (Not shown yet.)
8) Low technical risk. Based on the design of off the shelf regulators.
9) Fuel return line. (The only down side.)
10) Leaning over a wide range of mixtures by changing spring pressure.

The fuel mechanical pressure gauge will be mounted on the top of
the system to aid in tuning the engine. All one need do is
compare the gauge reading with the EGT or the wide band
O2 sensor. Also fuel pressure transients pulses will show on
the gauge allowing adjustments of the MAP dampers and
MAP controlled leaks in the back block.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.