Subject: Fitting the SS p-port tube to the RX8 rotor housing.
From: Rotary Engine
Date: 8/26/2007, 6:08 AM
To: AARotary Engine

Makes sure you bore the hole in the rotor housing .010" over size.
The .049" wall 2 inch OD SS 304 tube I got from Burns was out
near the tolerance limit of plus .005. I had to make
a centering fixture and turn it down in the lathe
as the holes bored in the RX8 rotor housings were only 2.005" dia..
Also welded tube is never really perfectly round.

Use Dykem to blue the end of the tube.
Use a small sharp scribe to mark the tube with a scratch.
I used a small cutoff disk in an air tool to cut the tube
to shape. Works very fast but don't try to cut exactly on the line.
Finish with a small bench grinder and or belt sander.
Here is what it looks like installed in the rotor housing
before welding. Hopefully that will get done today.

Here is a picture of one that Mark Steitel welded.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.