Subject: Gerotor oil pump
From: Rotary Engine
Date: 9/1/2007, 10:28 PM
To: AARotary Engine

This is a real cheap and easy oil pump
to implement. I am going to use it on the VTOL canard gear box
design. These are widely used in automatic transmission and
Ford V6, V8 and V10 modular engines. Not suitable for a
rotary as they are too far from the oil level and
may have trouble priming after some wear sets in.
No chains or sprockets are required. They run directly off
the main shaft with nothing more than a key way and are very low cost.

The VTOL canard gear box will have its own high pressure oil supply
complete with filter and oil cooler.
It is very hard to get the right size light weight  bearings when you are dealing
with four and five inch diameter rotor shafts so all bearings will be plain
pressure fed including the thrust bearings. More on that soon.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.