Paul
I am at the stage of trying to build a mount for a 20b to an Australian
Lightwing Speed 4000 fuselage.
Firewall mount dims are 715mm horizontal, 505mm vertical. Engine thrust
line needs to be at least 160mm below the top firewall mounts for cowl
clearance at top of engine, and prop flange using RWS RD1-C re-drive
needs to be 1100mm in front of firewall.
Any help for the mount dimensions and general mount design would be
greatly appreciated
Regards
**Andrew Martin**
Geraldton. Western Australia.
------------------------------------------------------------------------
I need to know the positions of the hard points on the firewall.
Are you in touch with the other aircraft rotor heads in Perth?
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.
Paul
Attached is a fairly rough drawing of the firewall, hopefully it has the
dims you need.
I have spoken to David McCandless but have not seen a rotary in a plane
as yet. I am 500km north of the city and rarely get there with enough
spare time. but do plan to meet up with him in the near future.
Regards
Andrew Martin
OK. That is good Martin. I'll work on it in a day or so,
Ian Beadle flys up that way once in a while as I recall.
His airport is about 100Km north of the city.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.
