<snip>
Andrew,
I will have to agree with everyone else here on the engine size. A 13B
PP is
plenty of HP- for the sport category you could get away with a single
rotor
at 125hp, however your most likely looking at GA.
With the 20 B you will have more power ( perhaps) more weight (
certainly,
100 lb) more complexity, more heat to manage and , will burn more fuel.
The
W&B will also be an issue.
The 180 hp needed is easy with a 13B, with over 200hp with a pp, why
would
you want more.
Nice plane but I would talk to the manufacture about their Firewall
forward
weight limit. A lot of things to consider with a heavier engine - engine
mounts, extra strength to take the extra weight - the list goes on and
on. I
would suggest that this plane wasn't built to take the power and weight
of
the 20B.
What air strip are you flying from, I/ we have contacts in Perth, which
could help with advice. I was just over there recently.
George (down under) Brisbane
Ok, looks like there are plenty of you with much more knowledge than I
regarding this power and weight subject advising against the 20b for my
plane. I'll still build up this 20b even if just for education and a
next project, but I won't be happy if I only manage 160hp out of a 13b
as that would be a bare minimum for the plane. The 4 place plane is
quite different than the 2 place depicted on their website, they share
the same fuse shell but frame and wings are built for the heavier gross
weight.
Expect lots of questions regarding building a 13b to produce 180-200hp
or if you think you can teach a novice to build a reliable P Port, go
ahead.
George my closest airport is Geraldton but the plane will live on my
Farm 500 km north of Perth.
Andrew
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.