Subject: Prop for sale
From: Rotary Engine
Date: 9/12/2007, 12:41 AM
To: AARotary Engine



   Now that have have better cooling, I am able to use more power and
   needed
   a bigger prop.  I installed a Catto 3-blade with more pitch and really
   loved it.

   My old prop, seen in these pictures was meant for a normally aspirated
   13B turning left handed (RD-1A and RD-1B).
   It is 68"x74" Aymar Demuth wood and served me well for 200 hrs.

   If you are like me you can use this as a cheap starter prop to get
   performance data that you will want before you get a custom prop built.

   $700 firm INCLUDES Shipping and the spinner seen in the picture (now in
   gray primer).

   --
   David Leonard

   Turbo Rotary RV-6 N4VY
   http://N4VY.RotaryRoster.net <http://N4VY.RotaryRoster.net>
   <http://N4VY.RotaryRoster.net>
   http://RotaryRoster.net

   I think this needs a bit more info Dave. What HP and RPM do you
   think it
   is suited for? The RD1A and RD1-B are 2.17:1 ratio gear boxes as I
   recall.
   Is that correct? What HP do you think you have now?
   How fast are you going and what is your climb rate?

   Paul Lamar ...No rotor no motor.

Too late, the prop is sold.

But to answer the questions, Yes 2.17:1

Everything else is really hard to pin down exactly.  RPM limit on a
wooden prop is more of a question of how much risk do you want to take,
none or just maybe a little to really get good performance.   I set the
prop limit to 3000 RPM somewhat arbitrarily.  I occasionally went higher
than that but usually kept it around 2700.

That prop would work well on any 1 or 2-seat RV (or other aircraft with
similar weight and drag) with a n.a. 13 B rotary.

Performance for me is a real gray area because the biggest factor is the
amount of boost I decide to run on a particular day, which is never full
power.   At Redline 3000 RPM that prop pulled my RV-6 around 180KTAS.
Empty weigh and moderate boost I would see 2000 FPM climb.

I flew for 70 hours normally aspirated with that prop.  My turbo intake
and exhaust were very poor breathers and I estimate I was only getting
about 140 h.p.   Climb was 800-1000 fpm and cruise about 145 KTAS.  Ed
Anderson and Jim Moser also have used the prop n.a. with much better
results.

New prop is a 64x78 3-blade.  It performs pretty much as expected.
Things (RPM and TAS and climb) are slower for a given MAP, but it has a
higher top end, slows down the engine for a given airspeed, and is much
smoother.

-- 
David Leonard

Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net
http://RotaryRoster.net <http://RotaryRoster.net>

What is the top speed now?

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.