> Hey Paul,
>
> I heard a rumor that Buly is going to Lycoming.. Is that true??
>
>
> Matt-
>
> Yes. He could not deal with the EFI. I don't blame him.
> For some one not trained in single chip microcomputer hardware
> it is real tough to deal with. The vast majority of people have
enough
> trouble with just simple wiring like lights and starters.
>
> You just can't see them electrons :)
>
> Paul Lamar ...No rotor no motor.
>
I am one of those who found EFI intimidating but I always thought I
would deal with it when the time came. However, there is almost a
continuous thread of problems faced by other builders trying to get
reliable performance out of the the electronic ignition and EFI
which of course I have been reading for years. I can't exaggerate
the relief I felt the when I decided to go to crank fired ignition
and a carb. It was a matter of accepting my own limitations. Jerry
Furthermore one is expected to solder 37 tiny wires on this
connector. I would say 80% of the people on here don't have the eye
sight,
skill and manual dexterity required to do this let alone the
electronic knowledge
to trouble shoot such a system.
I suggested years ago a simple printed circuit board adapter and screw
type connectors but the idea was rejected out of hand.
--
Paul Lamar ...No rotor no motor.
I have 670 hours now and zero problems with [the stock] EFI. Believe it or not my
airplane engine has never been flooded. Always starts hot or cold wx,
hot or cold engine.
Perry
Well you don't have an RX8 engine either :)
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.