Subject: Buly is Going Lyco (Too)?
From: Rotary Engine
Date: 9/17/2007, 10:06 AM
To: AARotary Engine




    > > Hey Paul,
    > >
    > > I heard a rumor that Buly is going to Lycoming..
    > Is that true??
    > >
    > >
    > > Matt-
    > >
    > > Yes. He could not deal with the EFI. I don't blame
    > him.
    > > For some one not trained in single chip
    > microcomputer hardware
    > > it is real tough to deal with. The vast majority
    > of people have enough
    > > trouble with just simple wiring like lights and
    > starters.
    > >
    > > You just can't see them electrons :)
    > >
    > > Paul Lamar ...No rotor no motor.
    > >
    >
    > I am one of those who found EFI intimidating but I
    > always thought I
    > would deal with it when the time came. However,
    > there is almost a
    > continuous thread of problems faced by other
    > builders trying to get
    > reliable performance out of the the electronic
    > ignition and EFI
    > which of course I have been reading for years. I
    > can't exaggerate
    > the relief I felt the when I decided to go to crank
    > fired ignition
    > and a carb. It was a matter of accepting my own
    > limitations. Jerry
    >
    >
    > Furthermore one is expected to solder 37 tiny wires
    > on this
    > connector. I would say 80% of the people on here
    > don't have the eye sight,
    > skill and manual dexterity required to do this let
    > alone the electronic knowledge
    > to trouble shoot such a system.
    >
    >
    > I suggested years ago a simple printed circuit board
    > adapter and screw
    > type connectors but the idea was rejected out of
    > hand.
    > --
    > Paul Lamar ...No rotor no motor.


   NO, NO NO! Soldering is out as far as the connectors
   for the computers goes- you will not get the
   consistent results that you need for reliable wiring.
   I was lucky enough to have Richard Martin show me the
   sub-D crimp style connectors. The crimpers make
   absolutely consistent connections with the pins, which
   you then insert into the connector body. If you put a
   pin in the wrong hole, you can take the removal tool,
   remove it and then put it in the right place. I would
   not have tried to do my wiring with the solder type
   pins. The connectors and gold plated pins, both female
   and male are available from one electronics store here
   in Seattle, but I am sure they are widely available.
   As far as the crimping tool goes, I think it costs
   about ~$100, but I got mine at Boeing Surplus for
   about $10, and then had to turn a die on a metal lathe
   for the size pins I was crimping. Crimping is the only
   way to go on the computer wiring.

   Brian Trubee

   What are you building Brian?
   Clifton



I'm building an RV-4 with a 13BREW ('93 gen III that I am using normally
aspirated). All I need now is a prop, elt and Dynon. I'm also rolling an
aluminum cowl with an English wheel. Actually, I'm planning on doing it-
I built one before, but I changed the spinner diameter and need to build
a new cowl. This will be the third so far, and I'm sure it will be "the
one".

I've had the engine started, but cannot tune it until I have a prop to
load it. Hope to be finished mid-winter.

Brian Trubee



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.