Subject: Buly is Going Lyco (Too)
From: Rotary Engine
Date: 9/18/2007, 7:56 PM
To: AARotary Engine



>>      > Hey Paul,
>>      >
>>      > I heard a rumor that Buly is going to Lycoming.. Is that true??
>>      >
>>      >
>>      > Matt-
>>      >
>>      > Yes. He could not deal with the EFI. I don't blame him.
>>      > For some one not trained in single chip microcomputer hardware
>>      > it is real tough to deal with. The vast majority of people have
>>     enough
>>      > trouble with just simple wiring like lights and starters.
>>      >
>>      > You just can't see them electrons :)
>>      >
>>      > Paul Lamar ...No rotor no motor.
>>      >
>>
>>     I am one of those who found EFI intimidating but I always thought I
>>     would deal with it when the time came. However, there is almost a
>>     continuous thread of problems faced by other builders trying to get
>>     reliable performance out of the the electronic ignition and EFI
>>     which of course I have been reading for years. I can't exaggerate
>>     the relief I felt the when I decided to go to crank fired ignition
>>     and a carb. It was a matter of accepting my own limitations. Jerry
>>
>>
>>     Furthermore one is expected to solder 37 tiny wires on this
>>     connector. I would say 80% of the people on here don't have the eye
>>     sight,
>>     skill and manual dexterity required to do this let alone the
>>     electronic knowledge
>>     to trouble shoot such a system.
>>
>>
>>     I suggested years ago a simple printed circuit board adapter and >> screw
>>     type connectors but the idea was rejected out of hand.
>>     --
>>     Paul Lamar ...No rotor no motor.
>>
>>
>> I have 670 hours now and zero problems with [the stock] EFI. Believe it >> or not my
>> airplane engine has never been flooded. Always starts hot or cold wx,
>> hot or cold engine.
>>
>> Perry
>>
>> Well you don't have an RX8 engine either :)
>>
>> -- >> Paul Lamar ...No rotor no motor.
>
>
> I think Perry has a good point; a well engineered EFI should be easier to
> maintain, and superior in all respects except power consumption.
>
> I am concerned that builders will give up on EFI out of hand after hearing
> about the problems people have encountered.
>
> I am actively working on the super simple low pressure dribble fuel
> injection system Paul suggested some time ago. My design goal is to deal
> with all the problems encountered so far, including power consumption. It
> will use a nano-power micro controller. The low pressure means that not a
> lot of power will be used by the pump. And the low pressure means a
> (somewhat) safer system.
>
> I am considering publishing a progress report. If anyone is interested, I
> will; if not I won't bother.
>
> Doc Custer
> Retired Software Engineer and sometime Audiologist
>
>
> I am definitely interested.
> -- > Paul Lamar ...No rotor no motor.

Doc,
I'm with you on this, and am working on my own carb low pressure injector. I
tend to agree with Jerry on the subject of high pressure injection - besides
it's fun.
George (down under)


Good to know, George. Maybe we can share experiences and cry on each
others shoulder. :)

Doc Custer

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.